Conﬁguring The Atm Uplink Port For In-Band Management - Nortel Passport 8250 Command Line Interface Manual

Nortel passport 8250 integrated access mux: user guide

Hide thumbs Also See for Passport 8250:

Table of Contents

52 Chapter 4 Other activities in the CLI

[<numPktsToRx>]

device receives from the remote host. If the number of packets is unspeciﬁed,

the routine waits for only one echo reply packet. If no packets are received

within 5 seconds, the Passport 8250 displays that there is no answer from the

remote host and exits the ping command.

Procedure

Example

The following is an example of sending a ICMP echo request packet from the

Passport 8250 device to a remote host at IP address 192.0.0.20 and asking for

the remote host to send one ICMP packet back to the Passport 8250 device.

Conﬁguring the ATM uplink port for in-band management

The ibconﬁg command conﬁgures the ATM uplink port for in-band

management. The syntax of the command is:

where

[set]

241-5101-201 R2.2

is the number of ICMP packets that the Passport 8250

Test that a remote host is reachable from the Passport 8250 device:

ping <hostIP> [<numPktsToRx>]

[Edgeplex CLI]: ping 192.0.0.20 1

ibconfig [set]

conﬁgures the ATM uplink port for in-band management

Note: Entering the ibconﬁg command without the [set] parameter

displays the current in-band conﬁguration parameters.

Table of Contents