Nortel Passport 8250 Command Line Interface Manual page 43

See "Converting time slots to hexadecimal format" (page 71) for
information on converting the number of time slots into hexadecimal
format.
See "Time slots" (page 36) for the rules for using time slots.
6 Create the structured connections:
map <port#i>[,<#j>] [<time slots>] <VPI#k> <VCI#l>
[CAS=<cas type>]
7 Verify that the connections were created:
mshow [<port#>[,<#j>]]
Example
The following is an example of creating a DS-1 structured Basic connection
for a single port. Time slot 1, VPI 200, and VCI 30 are assigned to the
connection. The connection is mapped to port 6 on service board 2. The
mshow command is used to verify that the connection was created.
[Edgeplex CLI]: 2
[T1-2]: map 6 0x000002 200 30 CAS=BASIC
[T1-2]: mshow 6
vpi=200 vci=30 --> card=2 port=6 channel(s)=0x00000002
Example
The following is an example of creating E1 structured Basic connections for
multiple ports. All E1 time slots, except 0 and 16, are assigned to the
connections. VPI 18 and VCI 10, 11, 12, and 13 are assigned to the
connections. The connections are mapped to ports 1, 2, 3, and 4 on service
board 2. The mshow command is used to verify that the connections were
created.
[Edgeplex CLI]: 2
[E1-2]: map 1,4 0xFFFEFFFE 18 10 CAS=BASIC
[E1-2]: mshow 1,4
vpi=18 vci=10 -> card=2 port=1 channel(s)=0xfffefffe
vpi=18 vci=11 -> card=2 port=2 channel(s)=0xfffefffe
vpi=18 vci=12 -> card=2 port=3 channel(s)=0xfffefffe
vpi=18 vci=13 -> card=2 port=4 channel(s)=0xfffefffe
Passport 8250 Command Line Interface Guide R2.2
Chapter 3 Provisioning ports and connections 43