Nortel Passport 8250 Command Line Interface Manual page 56

56 Chapter 4 Other activities in the CLI
Procedure
1
2
3
4
5
6
7
8
9
Example
The following is an example of configuring the redundant ATM uplink port
for automatic switching. The primary port and active port is port B. After
configuring the ATM uplink port, the urconfig command without the [set]
parameter is used to verify the urconfig parameters.
241-5101-201 R2.2
Display the urconfig parameters to set the active port and primary port
parameters:
urconfig [set]
automatic switching: off
active port: A
primary port: A
For the automatic switching parameter, press enter to move to the next
parameter.
For the active port parameter, enter B or press enter to accept port A.
For the primary port parameter, enter B or press enter to accept port A.
Display the urconfig parameters to set the automatic switching parameter:
urconfig [set]
For the automatic switching parameter, enter on:
For the active port field, press enter to move to the next parameter:
For the primary port field, press enter to move to the next parameter:
Verify the new settings:
urconfig
[Edgeplex CLI]: urconfig set
automatic switching: off
active port: A B
primary port: A B
[Edgeplex CLI]:urconfig set
automatic switching: off on
active port: B
primary port: B
[Edgeplex CLI]: urconfig