Nortel Passport 8250 Command Line Interface Manual page 39

Table 5 (continued)
Map command parameters
Parameter
[cdvt=<value>]
[PartialFill=<value>]
[MaxBuffSize=<value>]
(Sheet 2 of 3)
Chapter 3 Provisioning ports and connections 39
Values
For DS-1/E1 unstructured connections, the default value is 100.
See Table 6 "Cdvt and MaxBuffSize parameters default values"
(page 40) for the default values for structured connections.
Note: This document does not explain how to modify the default
value and we recommend that you do not change the default
value.
PartialFill is only used for structured Basic and structured CAS
connections. The default is 0 (zero) for no partial cell fill.
Note 1: The PartialFill parameter has to be greater than the
number of time slots assigned to a connection.
Note 2: This document does not explain how to modify the default
value and we recommend that you do not change the default
value.
For DS-1/E1 unstructured connections, the default value is 225
See Table 6 "Cdvt and MaxBuffSize parameters default values"
(page 40) for the default values for structured connections.
Note 1: The MaxBuffSize parameter has to be at least twice the
value of the cdvt parameter.
Note 2: This document does not explain how to modify the default
value and we recommend that you do not change the default
value.
Passport 8250 Command Line Interface Guide R2.2