Out-Of-Band Management Support - Nortel BayStack Instant Internet 400-S User Manual

Chapter 7

Out-of-band management support

This chapter describes how to set up your Instant Internet unit for out-of-band
management. This feature enables you to configure the Instant Internet unit
without installing the unit on a network or loading the Instant Internet
management software.
After you connect a dumb terminal or a smart terminal (for example, a PC, a
Macintosh, or a UNIX workstation) and terminal emulation software (for
example, HyperTerminal or ProComm Plus) to the unit's AUX port, you can use
remote access commands to configure the unit. For details, refer to Reference for
the BayStack Instant Internet Remote Access Commands Version 7.11.
You can use out-of-band management any time, including for initial
configuration, troubleshooting, or daily management of the unit. This chapter
describes how to use a 32-bit Windows® operating system and the HyperTerminal
terminal emulation software to:
•
•
These procedures assume that you have turned on the unit and no LEDs are
glowing red. For more information on installing the Instant Internet hardware
refer to
more information on the required connection cables, refer to
"Adapter cable pinout diagrams," on page
Connect to the unit with a PC for out-of-band management. For details, refer
to "Configuring the Instant Internet unit through a PC direct connection,"
next. You must supply a null modem cable (also referred to as a pc-to-pc file
transfer cable) to connect your PC to the Instant Internet unit.
Configure an external modem to be used for out-of-band management. For
details, refer to "Configuring the Instant Internet unit through a dial-up
connection" on page
dial-up modem to the Instant Internet unit.
Chapter 3, "Instant Internet 400-S hardware installation," on page
69. You must supply a DB9 serial cable to connect your
77.
Setting Up the BayStack Instant Internet 400-S Unit
65
35. For
Appendix B,