Accessing The Annex; Figure 3-1. Add Annex Dialog Box - Bay Networks NA Install Manual

Chapter 3 Configuration Examples
Installing Remote Annex Network Software for Windows
3-2
The Remote Annex will accept SNMP sets only from sources using
the community string q2cannex. You can further restrict the access
by including the IP address of the Quick2Config Annex host.
snmp community q2cannex 192.9.200.55 read-write
2. Invoke na, configure the Remote Annex to accept and process
SNMP command sets, and exit na:
% na
command: annex 129.9.200.62
command: set annex allow_snmp_sets y
command: quit
3. Enter the selected community string when invoking
Quick2Config Annex.

Accessing the Annex

The first step in configuring the Annex ports is to add the Annex:
1. Open Quick2Config Annex.
2. Choose File > Add Annex.
Quick2Config Annex opens a dialog box for identifying the Annex,
and specifying timeout and retry settings

Figure 3-1. Add Annex Dialog Box

3. Type the name of the Annex or its IP address in the Annex Name
box.
4. Change the Community String, Timeout and Retries settings, if
necessary.
(Figure 3-1).