Table of Contents
Advertisement
Setting Up a PPP Modem
After verifying the CLI connection, you can set the port to PPP or another
mode, and then test the Annex port setup.
1.
Select Port 2 in the tree view and click on the Interfaces tab.
Quick2Config Annex displays options for specifying addresses and
various protocols
Figure 3-10. Quick2Config Annex Modem Interfaces Tab
2.
Deselect Assign Addresses from acp_dialup in the Dial-up
Addresses box.
3.
Type the remote address in the Remote Address box.
This address is to be used for the client. Each port should have a
unique address.
Installing Remote Annex Network Software for Windows
Chapter 3
(Figure
3-10).
Configuration Examples
3-11
Advertisement
Table of Contents
