Table of Contents
Advertisement
Chapter 3
Configuration Examples
PRI Parameters
Installing Remote Annex Network Software for Windows
3-16
3.
Invoke NA, configure the Remote Annex to accept and process
SNMP command sets, and exit NA:
% na
command: annex 129.9.200.62
command: set annex allow_snmp_sets y
You can also use NA to set the set PRI parameters:
1.
Set the switch type to att or dms to match the type of your PRI
line.
command: set pri switch_type att
2.
Specify the distance between your RA6300 and the CSU by
selecting one of the following ranges: 0-25, 26-65, 66-100, 136-
185 or 186-210.
command: set pri dsx1_line_length 0-25
The default is 0-25.
3.
Enter show pri to check the settings.
command: show pri
PRI Generic Parameters
switch_type: "att"
num_b_channels: 0
dsx1_line_length: 0-25
buildout: 0dB
fdl_type: att
analog_encoding: auto
4.
Boot the RA6300 from its host.
command:boot
command:quit
Access the Annex
To access the RA6300 and configure it with Quick2Config:
1.
Open Quick2Config Annex.
2.
Choose File > Add Annex.
Quick2Config Annex opens a dialog box for identifying the Annex,
and specifying timeout and retry settings
(Figure
3-14).
Advertisement
Table of Contents
