Introduction; Description - Nortel 2001 Installation And Operation Manual

Page 78 of 302 Nortel Networks IP Phone 2004

Introduction

Description

553-3001-368 Standard 4.00
This section explains how to install and maintain the IP Phone 2004. For
information on using the IP Phone 2004, see the IP Phone 2004 User Guide.
This section contains the following procedures:
• Procedure 17, "Pre-installation checklist" on
• Procedure 18, "Installing an IP Phone 2004 for the first time" on
• Procedure 19, "Installing an IP Phone 2004 for the first time using
DHCP" on page
• Table 20,"'Disabling Auto Negotiate and enabling Full Duplex mode" on
page 104.
• Table 21, "Checking Ethernet Statistics" on
• Procedure 22, "Changing the TN of an existing IP Phone 2004" on
page 105.
• Procedure 23, "Replacing an IP Phone 2004" on
• Procedure 24, "Removing an IP Phone 2004 from service" on
Note: After an IP Phone has been installed and configured, if power is
to the phone is interrupted, re-entry of the IP parameters, Node Number,
TN, or re-acquisition of firmware is not required.
The IP Phone 2004 brings voice and data to the desktop environment. It
connects directly to the LAN through the Ethernet connection.
The IP Phone 2004 translates voice into data packets for transport using
Internet Protocol. A Dynamic Host Configuration Protocol (DHCP) server
can be used to provide information that enables the IP Phone 2004 network
connection, and connection to the Voice Gateway Media Card. The IP Phone
2004 uses the customer's IP network to communicate with the Call Server.
The IP Phone 2004 components are shown in Figure 8 and described in
Table 10 on page 79.
February 2005
97.
page 90.
page
page 104.
page 106.
page
93.
106.