Nortel 2001 Installation And Operation Manual page 94

Page 94 of 302 Nortel Networks IP Phone 2004
553-3001-368 Standard 4.00
port located on the back of the telephone (identified with a LAN icon).
The other end of the CAT5 Ethernet cable plugs into the IP network.
b. For a telephone sharing a LAN access with a PC:
Connect one end of the CAT5 Ethernet cable to the LAN ethernet
jack located on the back of the telephone (identified with a LAN icon,
see Figure 6 on
a second CAT5 Ethernet cable into the PC ethernet jack located on
the back of the telephone (identified with a PC icon, see Figure 6 on
page 61) and the other end into the computer.
Timing information
There are only four seconds between plugging in the IP Phone 2004 's
power transformer and the appearance of the Nortel Networks logo on
the display. When you see the logo, you have one second to respond by
pressing the four feature keys at the bottom of the display in sequence
from left to right. If you miss the one second response time, the IP
Phone 2004 attempts to locate the connect server. Wait until it is
finished, and then begin the power up sequence again.
5 Power the IP Phone 2004 using either the Power over Ethernet or an AC
power transformer (local power).
a. If local power is used, plug the AC power transformer into the nearest
power outlet.
b. Ensure the correct AC power transformer is used. The voltage rating
of the transformer must match the wall outlet voltage. Refer to Table
12 on page 89. Connect the power jack as shown in Figure 6 on
page 61.
6 When the Nortel Networks logo appears on the display, immediately
press the four feature keys at the bottom of the display in sequence from
left to right.
7 At the prompt DHCP Yes/No?, select No.
8 Enter the following information provided by your system administrator:
Screen prompt
set IP
February 2005
page 61) and the other end to the IP network. Insert
IMPORTANT!
Description
a valid IP Phone 2004 IP address