10/100Base-Tx Ethernet Interface Card; Figure 76 10/100Base-Tx Ethernet Interface Card (All Models Except Vpn Router 1100); Figure 77 10/100Base-Tx Ethernet Interface Card (For The Vpn Router 1100 Only) - Nortel Contivity 2600 Install Manual

10/100BASE-TX Ethernet interface card

The 10/100BASE-TX Ethernet interface card has a single RJ-45 connector that
provides the signals needed to interface to 10BASE-T and 100BASE-TX Ethernet
equipment.
Figure 76
except the VPN Router 1100.
Figure 76 10/100BASE-TX Ethernet interface card (all models except VPN
Router 1100)
Figure 77
1100.
Figure 77 10/100BASE-TX Ethernet interface card (for the VPN Router 1100
only)
The 10/100BASE-TX Ethernet interface card for the VPN Router 1100 looks very
similar to
page
Depending on whether you use the interface for 10BASE-T or 100BASE-TX
operation, select cables for the interface as follows:
•
shows the 10/100BASE-TX Ethernet interface card for all VPN Routers
shows the 10/100BASE-TX Ethernet interface card for the VPN Router
Figure 77. However, the cable pinouts are different
184).
100BASE-TX connections require Category 5 twisted-pair wire. The
100BASE-TX specification supports 100 Mb/s transmission over two pairs of
Category 5 twisted-pair Ethernet wiring: one pair each for transmit and
receive operations.
Appendix A Technical specifications 183
Nortel VPN Router Installation — Hardware Options
CS260009A
CS260009B
(Table 18 on