Installing Or Replacing Option Cards; Table 13 Supported Option Cards For The Nortel Vpn Router 4600 - Nortel Contivity 2600 Install Manual

134 Chapter 8 Nortel VPN Router 4600 option installation

Installing or replacing option cards

The VPN Router 4600 has six slots for option cards
section provides instructions about adding new option cards to the gateway or, if
necessary, replacing an existing card. The following procedure is for Nortel
trained service personnel only.
Table 13

Table 13 Supported option cards for the Nortel VPN Router 4600

Option card
VPN Router Security Accelerator
Hardware Accelerator
10/100BASE-TX Ethernet interface
1000BASE-T (1000 GT) Ethernet
interface
1000BASE-T (1000 MT) interface
(copper)
1000BASE-SX interface (fiber)
56/64K channel service unit/digital service
unit
Integrated Services Digital Network
(ISDN) BRI S/T or U interface
T1 CSU/DSU WAN interface (full-height)
T1/E1 CSU/DSU WAN interface
(half-height)
Quad T1/E1 CSU/DSU WAN interface
V.90 modem interface
Single V.35/X.21 WAN interface
(full-height)
Single V.35/X.21 WAN interface
(half-height)
HSSI WAN interface
1 The VPN Router 4600 must be running Version 4.90 or later.
NN46110-317 02.01
lists the option cards that you can install in the VPN Router 4600.
2
3
4
CSU/DSU) WAN interface
(
9
10
11
Maximum
number
1
2
6
6
2
5
5
6
5
7
5
5
3
8
5
5
5
2
(Figure 48 on page 133). This
Restrictions
Install two cards of either type,
or one card of each type. Do not
install the VPN Router Security
Accelerator card in slot 4.
Install two 1000BASE-T (1000
MT) cards, two 1000BASE-SX
cards, or one card of each type.
Do not install either card in slot
4.
For E1 support, you must install
the half-height interface card.