Installing or replacing option cards
The VPN Router 2700 and 2600 have four slots for option cards
page
gateway or, if necessary, replacing an existing card.
Table 7
2700.
Table 7 Supported option cards for the Nortel VPN Router 2600 and 2700
Option card
SSL VPN Module 1000
VPN Router Security Accelerator
Hardware Accelerator
10/100BASE-TX Ethernet interface
1000BASE-T (1000 GT) Ethernet
interface
4
1000BASE-T (1000 MT) interface
(copper)
1000BASE-SX interface (fiber)
56/64K channel service unit/digital
service unit
CSU/DSU) WAN interface
(
Asymmetric digital subscriber line
ADSL) WAN interface
(
ISDN BRI S/T or U interface
T1 CSU/DSU WAN interface (full-height)
T1/E1 CSU/DSU WAN interface
(half-height)
Quad T1/E1 CSU/DSU WAN interface
V.90 modem interface
Chapter 6 Nortel VPN Router 2700 and 2600 option installation 103
101). This section provides instructions about adding new option cards to the
Note: The 1000BASE-T (1000 GT) Ethernet interface card only
operates at 10/100 Mbit/s on the VPN Router 2600.
lists the option cards that you can install in the VPN Router 2600 and
Maximum
number
1
2
3
5
6
7
Restrictions
1
Install this card in slot 1 only.
Install two cards of either type, or one card of each
2
type. (But see
Hardware Accelerator card in slot 4.
4
4
Install two 1000BASE-T (1000 MT) cards, two
1000BASE-SX cards, or one card of each type. (But
2
see
Table 8 on page
4
4
4
4
For E1 support, you must install the half-height
4
interface card.
3
4
If an SSL VPN Module 1000 is in slot 1, do not
install the V.90 modem interface card in slot 2.
Nortel VPN Router Installation — Hardware Options
(Figure 34 on
Table 8 on page
104.) Do not install a
104.)