90 Chapter 5 Nortel VPN Router 1750 option installation
Installing or replacing an option card
To install or replace an option card:
1
2
3
4
5
6
NN46110-317 02.01
Shut down the VPN Router 1750 using the Web GUI or the CLI, and then
unplug it as described in
hardware" on page
82.
Warning: Risk of electric shock
Turn off the VPN Router 1750 and unplug it before you attempt to install
an option card.
Remove the front bezel from the chassis, and then remove the chassis from the
equipment rack (see
Remove the top cover from the chassis (see
top cover" on page
83).
Attach the antistatic wrist strap that was shipped with the VPN Router 1750
(see
"Attaching the antistatic wrist strap" on page
Locate the slot where you plan to install the new or replacement option card.
Caution: Risk of equipment damage
Do not try to install a HSSI WAN interface card or a Hardware
Accelerator card in slot 4.
Remove the filler panel screw, and pull out the filler panel (or the option card
that you are replacing) from the slot
"Shutting down the system to add or replace
"Removing the front bezel and top cover" on page
(Figure
"Removing the front bezel and
87).
29).
83).