Setting Up The Nortel Vpn Router 1010, 1050, And 1100; Default Configuration - Nortel Contivity 1100 Configuration Manual

Chapter 3

Setting up the Nortel VPN Router 1010, 1050, and 1100

This chapter provides instructions for the network administrator who is
responsible for the Nortel VPN Router 1010, 1050, and 1100 located at branch
office sites. If you are at a branch office site and you need to connect the Nortel
VPN Router 1010, 1050, or 1100 to the network, see
access" on page
Unless you are the network administrator, you need not read the rest of this
chapter
The Nortel VPN Router 1010, 1050, and 1100 series of switches provides support
for five (5) tunnels at introduction and 30 tunnels for licensing. The maximum
tunnels include the sum of all branch office, client, and management tunnels
combined. For example, if one management tunnel and two branch office tunnels
are open, only two client tunnels can be connected initially (27 client tunnels with
the 30 tunnel license). The license is for 25 additional tunnels. LDAP supports
150 entries.

Default configuration

The 1010, 1050, 1100 default configuration is set up to meet requirements for the
majority of small office connections. This configuration includes a public
interface configured for IP and can receive an address via DHCP from the ISP.
The private side has the DHCP server enabled and the DHCP address pool set to
192.168.1.3–192.168.1.254.
Figure 8 on page 60
67. (This information was also included with the VPN Router.)
show a typical default configuration.window
Nortel VPN Router Configuration — Basic Features
"Connecting for Internet
59