Ring; Wavetable - Roland SH-4d Owner's Manual

Creating a Tone

RING

Parameter Controllers
Osc 1–2 [2] knob (on the top
screen only)
Waveform
Coarse Tune PITCH
Fine Tune SHIFT+PITCH
Modulator TIMBRE
Tune
Mod Fine Tune SHIFT+TIMBRE
[OSC 1] slider
Bottom 1
[OSC 2] slider
Shape
FXM [OSC 3] slider
[OSC 4] slider
Bottom 2
[OSC 3] button
FXM Speed

WAVETABLE

Parameter
[2] knob (on the top screen
Wave Number
only)
PITCH
Coarse Tune
Pos LFO Depth TIMBRE
Position [OSC 1] slider
34
Value
SINE, TRI,
SQR, SAW
-24–+24
-50–+50
-48–+48
-50–+50
0–127
0–63
0–16
0–127
1–4
Controllers Value
1–31
-24–
+24
0–63
0–127
This sets the waveform.
Specifies the pitch in semitone steps (maximum ±2 octaves).
Specifies the pitch in cents (maximum ±50 cents).
Specifies the pitch for oscillator 2 in semitone steps (maximum ±4
octaves).
Specifies the pitch for oscillator 2 in cents (maximum ±50 cents).
Sets the loudness of oscillator 1's signal that does not pass through
the ring modulator.
Distorts the waveform of oscillator 2, and adds a frequency
component one octave lower than the original waveform.
Sets the depth of FXM frequency modulation.
Sets the loudness of oscillator 2's signal that does not pass through
the ring modulator.
Sets the method used for FXM frequency modulation.
Larger values produce a rougher sound, and smaller values produce a
more metallic sound.
Sets the wave number.
Specifies the pitch in semitone steps (maximum ±2 octaves).
Sets how much the LFO is applied (depth) to the wave position.
Sets the wave position on the selected wave number.
Explanation
Explanation