Juno-106 - Roland SH-4d Owner's Manual

Creating a Tone

JUNO-106

Parameter Controllers
PITCH
Coarse Tune
SHIFT+PITCH
Fine Tune
TIMBRE
Pulse Width
LFO Pitch [OSC 1] slider
Depth
[OSC 2] slider
PWM Depth
Sub Osc Level [OSC 3] slider
Noise Level [OSC 4] slider
[OSC 2]
Square Switch
button
[OSC 3]
Saw Switch
button
32
Value
-24– Specifies the pitch in semitone steps (maximum ±2 octaves).
+24
-50– Specifies the pitch in cents (maximum ±50 cents).
+50
0–63 Changes the duty ratio of the pulse width to alter the waveform.
* A value of zero results in a 50:50% duty ratio.
0–100 Sets the depth of the LFO when it is applied to the pitch.
0–63 Sets how much the LFO is applied (depth) to the PW (pulse width) of the square
wave.
The pulse width is modulated according to the LFO settings.
0–127 Sets the sub-oscillator volume.
0–127 Sets the noise generator volume.
OFF, ON Turns the square wave on/off.
OFF, ON Turns the sawtooth wave on/off.
Explanation