Ds -> Delay (Distortion -> Delay); Od/Ds -> T. Wah (Overdrive/Distortion -> Touch Wah) - Roland SH-4d Owner's Manual

Parameter Value
-98–+98 [%]
Flg Fbk
D100: 0W–D0:
Flg Bal
100W
Level 0–127
DS -> Delay (Distortion -> Delay)
Parameter
0–127
Dist Drive
L64–63R
Dist Pan
OFF, ON
Delay
Sync
D. Time 1–2600
D.Time Nt Note(P.167)
-98–+98 [%]
Delay Fbk
200, 250, 315, 400, 500, 630, 800, 1000, 1250,
Dly HF 1600, 2000, 2500, 3150, 4000, 5000, 6300, 8000,
BYPASS [Hz]
D100: 0W–D0: 100W
Dly Bal
Level 0–127
OD/DS -> T. Wah (Overdrive/Distortion -> Touch Wah)
Parameter Value
Drive OFF, ON
Switch
D. Type OVERDRIVE, DISTORTION
0–127
Drive
Tone 0–127
Amp Switch OFF, ON
Adjusts the proportion of the flanger sound that is fed back into the effect.
Negative (-) settings will invert the phase.
Adjusts the volume balance between the sound that is sent through the flanger (W) and the
sound that is not sent through the flanger (D).
Output Level
Value
Turns overdrive/distortion on/off
Type of distortion
Degree of distortion
Also changes the volume.
Sound quality of the Overdrive effect
Turns the Amp Simulator on/off.
Explanation
Explanation
Degree of distortion
Also changes the volume.
Stereo location of the distortion sound
If this is ON, the rate synchronizes with the tempo of the rhythm.
Tempo (Pattern)
Tempo (System)(P.76)
Delay time from when the original sound is heard to when the
delay sound is heard
Adjusts the proportion of the delay sound that is fed back into the
effect.
Negative (-) settings will invert the phase.
Adjusts the frequency above which sound fed back to the effect
will be cut. If you do not want to cut the high frequencies, set this
parameter to BYPASS.
Adjusts the volume balance between the sound that is sent
through the delay (W) and the sound that is not sent through the
delay (D).
Output Level
Explanation
MFX Parameters
151