58
Chapter 5 DIP switch settings
Table 10
conditions.
Table 10 Switch settings for resetting factory default conditions
Resetting your Instant Internet unit
Before you reset your Instant Internet unit, be sure to back up the configuration.
If you back up the configuration, you can easily restore it. For details, refer to
Using the BayStack Instant Internet Management Software Version 7.11.
To reset your Instant Internet unit:
1
Turn off your unit.
2
Set the switches to the configuration you want.
Refer to
209375-A
shows the switch settings for resetting your unit to factory default
1
2
OFF
•
•
ON
Caution: If you use these switch settings to reset your unit to factory
default conditions, the following user-defined settings are removed or
reset: password, hosts, port mappings, unit configuration, access
restrictions, unit registration, and encryption authorization.
If you purchased and installed the 3DES Encryption Module (part number
CQ1010005), you need to reinstall it.
If you used the switch settings in
configuration switch settings, these settings are re-enabled.
"Switch settings for special configurations" on page
3
4
5
•
•
•
Table 9
to disable the reset password and
6
7
8
•
•
•
56.