Power Cords - Nortel BayStack Instant Internet 400-S User Manual

Table 3 Communications interface cards (continued)
Interface name Interface card
ISDN S/T
T1
E1
V.35/X.21
1-Meg Modem

Power cords

The AC power receptacle accepts the AC power cord (supplied). For installation
outside of North America, make sure that you have the proper power cord for your
region. Any cord used must have a CEE-22 standard V female connector on one
end and must meet the IEC 320-030 specifications.
Chapter 3 Instant Internet 400-S hardware installation
1 2
Setting Up the BayStack Instant Internet 400-S Unit
Type
ISDN interface card (no
integrated NT1) with one POTS
connector and one RJ-45
connector.
10047EB
T1 interface card (leased-line)
with one RJ-48 connector for
T1.
9854EB
E1 interface card (leased-line)
with one RJ-48 connector for
E1.
9854EB
A 26-pin autosensing serial
connector.
9853EB
1-Meg modem interface card
LOOP
with one RJ-11 connector for
SYNC
the phone (outgoing to modem)
LOOP
RX/TX
and one RJ-11 connector for the
9874EC telco (incoming from wall jack).
39