Interfaces; Figure 2 Rear Panel Of The Instant Internet 400-S Unit - Nortel BayStack Instant Internet 400-S User Manual

Figure 2 Rear panel of the Instant Internet 400-S unit

Option card
(to telco)
A
Aux Configure
AUX port
(to PC
or modem)
Configuration
switches
Warning: The Instant Internet unit contains a lithium battery. There is a
danger of explosion if the battery is replaced incorrectly. The battery
should be replaced only by factory authorized personnel.

Interfaces

Each unit has a autosensing, autonegotiating seven-port 10/100 Ethernet switch
and two full-duplex/half-duplex autonegotiating Ethernet LAN interface cards.
Depending on your unit, you can have multiple communications interface cards.
Note: The interface card(s) in your Instant Internet unit may not look
exactly like those depicted in the illustrations.
Chapter 3 Instant Internet 400-S hardware installation
Option card
(backup connection
to telco)
Link Act
Ethernet
10/100
Eth2 connection Eth3 connection
(to router
or bridge)
Setting Up the BayStack Instant Internet 400-S Unit
Power voltage
selector switch
115 / 230 V ~
50 / 60 Hz , 4A / 2A
B
C
Power Power
switch supply
connector
37
Fan
9860EB