LEDs 1 through 8 and the Power LED during operation
After the power-up sequence is complete, the LEDs indicate status and activity
during operation as shown in
Table 11 LED status and appearance during operation
LED #
Color
Power Green
Power Green and
Amber
1
Green
2
Green
2
Green and
Amber
2
Amber
3-8
Green
3-8
Green
3-8
Green and
Amber
3-8
Red
Note: The "indicated interface" is the interface associated with the
LED's number. This information is available in the main dialog box of the
Setup program. For more information, refer to Using the BayStack Instant
Internet Management Software Version 7.11.
Using the seven-port autosensing switch LEDs for
troubleshooting
The seven-port autosensing switch has two LEDs for each port on the switch. The
top row of these LEDs displays speed, link, and activity. The bottom row of LEDs
displays whether the unit is operating in full- or half-duplex mode.
Chapter 6 LEDs: support and diagnostic functions
Table
11.
Appearance
Meaning
Solid
Unit has electrical power and is turned on.
Solid Green and
Unit is updating flash ROM. DO NOT TURN
Flashing Amber
THE UNIT OFF until light returns to green.
Blinking
Unit is operating normally.
Solid
Unit is ready to service clients.
Solid Green and
Unit is communicating with clients.
Flashing Amber
Solid
Unit is ready to run setup but cannot service
clients (normally occurs before unit has been
configured).
Solid
Indicated interface (see Note below) is online.
Flashing
Indicated interface (see Note below) is dialing or
attempting connection.
Solid Green and
Traffic is on the indicated interface.
Flashing Amber
Solid
Indicated interface (see Note below) has failed.
Setting Up the BayStack Instant Internet 400-S Unit
63