Chapter 1 Introduction; Instant Internet Package - Nortel BayStack Instant Internet 400-S User Manual

Chapter 1
Introduction
This chapter introduces your Instant Internet 400-S unit and describes package
contents, available options for your Instant Internet unit, and any requirements
and compatibility issues.

Instant Internet package

The Instant Internet package contains:
•
•
Caution: Before you install your unit, make sure that the power voltage
selector switch setting matches your power voltage. For details, refer to
"Setting the voltage selector switch" on page
Instant Internet 400-S unit
Depending on the type of connection you ordered, your Instant Internet
package contains one or more of the following connector cables:
— RJ-11 cable (phone cord) for a dial-up connection or 1-Meg modem
connection
— ISDN cable for an Integrated Service Digital Network (ISDN) connection
— Two RJ-45 cables for a 10BASE-T or 100BASE-T Ethernet connection
— Two RJ-45 crossover cables for a 10BASE-T or 100BASE-T Ethernet
connection
— RJ-48 cable for a T1 connection or an E1 connection
Note: If you ordered your Instant Internet unit for use with a V.35 or
X.21 modem, you must provide the connection cable. For pinout
diagrams for V.35 and X.21 adapter cables, refer to
cable pinout diagrams," on page 77.
Setting Up the BayStack Instant Internet 400-S Unit
42.
Appendix B, "Adapter
25