Cli Quickstart Command - Nortel 2360 Configuration Manual

62 WSS setup methods
7
After guiding you through the configuration, the wizard displays a summary of the configuration values
you selected. Here is an example:
8
Review the configuration settings, then click Finish to save the changes or click Back to change settings.
If you want to quit for now and start over later, click Cancel.
If you click Finish, the wizard saves the configuration settings into the switch's configuration file. If the
switch is rebooted, the configuration settings are restored when the reboot is finished.
The switch is ready for operation. You do not need to restart the switch.
Caution!
seconds! On a 2350 that is fully booted, the factory reset switch erases the configuration
if held for five seconds or more. If you do accidentally erase the configuration, you can use
the Web Quick Start to reconfigure the switch.

CLI quickstart command

The quickstart command runs a script that interactively helps you configure the following items:
• System name
• Country code (regulatory domain)
• System IP address
NN47250-500 (320657-F Version 02.01)
On a 2350, do not press the factory reset switch for more than four