Specifying The Country Of Operation - Nortel 2360 Configuration Manual

• Configure a service profile to set SSID and encryption parameters. (See
(page 244).)
• Configure a radio profile. (See
• If required, configure the channel, transmit power, and external antenna type on each radio. (See
"Configuring radio-specific parameters" (page
• Map the radio profile to a service profile. (See
• Assign the radio profile to radios and enable the radios. (See
radios" (page 271).)

Specifying the country of operation

You must specify the country in which you plan to operate the WSS and its APs. WSS Software does not
allow you to configure or enable the AP radios until you specify the country of operation.
Note.
In countries where Dynamic Frequency Selection (DFS) is required, WSS
Software performs the appropriate check for radar. If radar is detected on a channel, the AP
radio stops using the channel for the amount of time specified in the specified country's
regulations. WSS Software also generates a log message to notify you when this occurs.
Note.
For a complete listing of the models in the WLAN Series 2332 and their respective
countries of operation, please visit the Nortel Support website
http://www.nortel.com/support.
The Series 2332 access point has been region-locked to meet geographic regulatory
restrictions. Each model is associated to a specific regulatory domain and subsequent
country of operation. During installation, the access point model and wireless security
switch regulatory domain must match or the access point will not operate.
To specify the country, use the following command:
set system countrycode code
For a complete listing of the approved two-letter country codes, refer to the "Approved Countries for the
WLAN 2300 Series Components" at http://www.nortel.com/support.
To verify the configuration change, use the following command:
show system
The following commands set the country code to US (United States) and verify the setting:
"Configuring a radio profile" (page
255).)
"Mapping the radio profile to service profiles" (page
Nortel WLAN—Security Switch 2300 Series Configuration Guide
"Configuring a service profile"
250).)
"Assigning a radio profile and enabling
Configuring APs 229
270).)