Displaying Poe State; Displaying Port Statistics; Clearing Statistics Counters - Nortel 2360 Configuration Manual

Displaying PoE state

To display the PoE state of a port, use the following command:
show port poe [port-list]
To display PoE information for ports 2 and 4, type the following command:
WSS# show port poe 2,4
Port Name Link Status
2 2 down
4 4 up
In this example, PoE is disabled on port 2 and enabled on port 4. The AP connected to port 4 is drawing 1.44 W of power
from the WSS.
(For more information about the fields in the output, see the
Reference.)

Displaying port statistics

To display port statistics, use the following command:
show port counters [octets | packets | receive-errors | transmit-errors | collisions |
receive-etherstats | transmit-etherstats] [port port-list]
You can specify one statistic type with the command. For example, to display octet statistics for port 3, type the
following command:
WSS# show port counters octets port 3
Port Status
==============================================================================
3 Up 27965420
(For information about the fields in the output, see the
Reference.)
Note.
To display all types of statistics with the same command, use the monitor port
counters command. (See

Clearing statistics counters

To clear all port statistics counters, use the following command:
clear port counters
The counters begin incrementing again, starting from 0.
Port Type PoE config
AP disabled
AP enabled
Rx Octets Tx Octets
34886544
"Monitoring port statistics" (page
Nortel WLAN—Security Switch 2300 Series Configuration Guide
Configuring and managing ports and VLANs 99
PoE Draw
off
1.44
Nortel WLAN Security Switch 2300 Series Command Line
Nortel WLAN Security Switch 2300 Series Command Line
100).)