Yamaha R15 2022 Service Manual page 99

1. Fuel tank assembly
2. Fuel tank breather hose
3. Throttle cable (Pull)
4. Throttle cable (Return)
5. Left handlebar switch lead
6. Front wheel speed sensor
7. VVA lead
8. Spark plug lead
9. O sensor lead
2
10. Coolant temperature sensor lead
11. Starting motor
12. Radiator hose (Thermostat to water pump)
13. Starting motor lead
14. Purge hose (Canister to throttle body)
15. Throttle body sensor assembly lead
16. FID (Fast idle solenoid device) lead
17. FID (Fast idle solenoid device)
18. Ignition coil lead
19. Frame component
20. Ignition coil
21. Rubber cover
22. Main switch lead
23. Rubber cover
24. Right handlebar switch lead
25. Negative battery lead
26. Right side under cover bracket
CABLE ROUTING
A. Insert spark plug lead of ignition coil into spark plug
cap.
B. Clamped coolant temperature sensor lead to frame
component on white tape.
C. O sensor connector shall be bottom side of plate.
2
D. Plastic band shall not be cut. Direct tip of plastic
band upper side and inside of ignition coil. Ignition
coil lead shall be clamped on white tape with frame
component.
E. Plastic band shall not be cut. Direct tip of plastic
band forward and inside ignition coil. Ignition coil
lead shall be clamped on white tape with frame.
F. Insert the rubber cover into frame component.
G. Cover the main switch lead, left handlebar switch
lead & connector, right handlebar switch connector
and front wheel speed sensor connector with
rubber cover.
H. Rubber cover shall include lead and be clamped.
Clamp shall be clamped so as not to be rotated.
Tip of plastic band shall be directed downward.
Plastic band shall not be cut.
I. Tip of plastic band shall be directed backward.
Plastic band shall not be cut. Positive battery lead
shall be clamped to frame component on white
tape.
J. Tighten clamp on white paint of O
clamp shall be inserted on to hole of right side
under cover bracket. Protector twisting shall be
allowed after insertion of clamp into right side
under cover bracket.
K. Tip of plastic band shall be 10 mm max. direction
of clamp needs not be controlled.
L. Coolant temperature sensor lead through inside of
radiator hose (thermostat to water pump)
M. Plastic band shall not be cut. Direct tip of plastic
backward.
2-42
SPEC
sensor lead,
2