Yamaha R15 2022 Service Manual page 233

3. Install new chain link "1" with O-rings "2" and
fix on drive chain "3".
3
4. Install O-rings "1" and outer plate "2" with joint
"3".
1
2
5. During installation of outer plate "1" remem-
ber writing side "DID" should be outward.
6. Attach pressure plate "1" with pressure bolt
holder set "2" and screw it for locking.
• Install pressure plate as shown in illustration
and fixing of link plate in drive chain.
2
A
1 2
3
2
1
1
CHAIN DRIVE
TIP
Clamp holder locking screw should be set on "A"
position.
7. After installing the joint plate "1" from special
tool, remove pressure plate and adjust the
clamp to "B" position and screw in the pres-
sure bolt for flaring of rivet of both the link pins
by tightening the pressure bolt.
TIP
During flaring, Ensure Cutter pin is in line with
chain link pin.
A
A. Drive chain roller
B. Drive chain sprocket
IMPORTANT:
1. Remove the special tool and measure
flaring size of riveted pins.
Flaring size of riveted pins
4.65–4.95 mm (0.18–0.19 in)
8. Tighten the axle nut, and then tighten the
chain adjuster locknuts to the specified
torque.
Tightening torque:
Rear wheel axle nut:
59 N·m (5.9 kgf·m, 44 lb·ft)
Drive chain adjusting locknut:
16 N·m (1.6 kgf·m, 12 lb·ft)
4-88
CHAS
B
1