Yamaha R15 2022 Service Manual page 205

5. Install:
• Clutch lever holder "1"
Clutch lever holder bolt
7 N·m (0.7 kgf·m, 5.2 lb·ft)
TIP
Align the end of the clutch lever holder with the
punch mark "a" on the left handlebar.
1
6. Install:
• Clutch lever
• Clutch switch "1"
TIP
Align the projection "a" on the clutch switch with
the slit "b" in the clutch lever holder.
a
b
7. Connect:
• Clutch cable
HANDLEBARS
TIP
Lubricate the end of the clutch cable with a thin
coat of lithium-soap-based grease.
8. Install:
• Handlebar switch (left) "1"
TIP
1
Align the projection "a" on the left handlebar
switch with the hole "b" in the left handlebar.
9. Connect:
a
• Clutch switch coupler
10.Install:
• Handlebar grip "1"
• Handlebar weight (left)
• Grip end (left) "2"
EWA13700
Do not touch the handlebar grip until the rub-
ber adhesive has fully dried.
TIP
There should be 0.4–4.5 mm (0.02–0.17 in) of
clearance "a" between the handlebar grip and
the left grip end.
1
4-60
1
1
a. Apply a thin coat of rubber adhesive onto
the end of the left handlebar.
b. Slide the handlebar grip over the end of
the left handlebar.
c. Wipe off any excess rubber adhesive with
a clean rag.
WARNING
CHAS
a
b