Yamaha R15 2022 Service Manual page 93

1. Clutch cable
2. Left side tank rail
3. Horn lead
4. Fuel sender lead
5. Fuel pump lead
6. Fuel hose
7. Radiator cover
8. Gear position switch lead
9. Sidestand switch lead
10. Under cover bracket (Left)
11. Quick shift switch lead
12. Radiator hose (Overflow)
13. Stay
14. O
sensor lead
2
15. Throttle cable (Return)
16. Throttle cable (Pull)
17. Horn bracket
18. Left handlebar switch lead
19. Wire guide
20. Frame component
21. Cylinder head breather hose
22. Air filter assembly
23. Fuel drain hose
24. Plastic band
25. Wire harness assembly
26. AC magneto lead
27. Rectifier regulator assembly
28. Radiator inlet hose
CABLE ROUTING
A. Joint connector shall be placed so that rubber
opening face downward as shown in drawing.
B. Clamp shall be touched with left side tank rail.
C. No slack within the span illustrated by arrows when
clamp the wire.
D. Clamp of side stand switch lead shall be inserted
into left under cover bracket (Left).
E. Pass the clutch cable through engine assembly
guide.
F. Sidestand switch lead shall be clamped at the
center of wire guide of stay.
G. Pass the clutch cable through guide.
H. To headlight assembly, meter assembly, front turn
signal & auxiliary light.
I. Terminal of horn lead shall be directed to outside
of motorcycle.
J. Left handlebar switch lead shall pass outside of
throttle cables and clutch cable.
K. Pass the fuel drain hose above the cylinder head
breather hose of air filter assembly.
L. AC magneto lead shall be clamped to frame on
white tape. Tip of plastic band shall be directed
inside of vehicle. Do not cut plastic band.
M. Clamp of quick shift switch lead shall be inserted
into left under cover bracket (Left).
N. Cut tip of the plastic band to 10 mm maximum. Tip
direction of plastic band needs not be controlled.
O. Either plastic band install direction shall be
allowed. Plastic band shall not be cut. Direct tip of
plastic band in forward direction.
P. Plastic band shall not be cut. Direct tip of plastic
band in downward direction. Sidestand switch lead
and quick shift switch lead shall be clamped to stay
on white tape.
2-36
SPEC