Yamaha R15 2022 Service Manual page 95

1. AC magneto connector cover
2. Air filter assembly
3. CCU (Communication control unit)
4. Tail light unit lead
5. Fender
6. Negative battery lead
7. Back stay
8. Engine stay
9. AC magneto lead
10. Frame component
11. Lean angle sensor lead
12. Rear brake light switch lead
13. Wire harness assembly
14. OBD lead
15. Cross tube
16. Gear position switch lead
17. Battery band
18. Battery
19. Rear arm component
20. Engine assembly
21. Fuel drain hose
22. Canister breather hose
23. Main stand bracket
CABLE ROUTING
A. Route rear turn signal light lead and license plate
light lead as shown.
B. AC magneto lead and neural switch lead and
negative battery lead shall clamped to the frame
component. Tip of plastic band shall be parallel
with back stay.
C. Negative battery lead shall be touched with engine
stay.
D. Tip of fuel drain hose and canister breather hose
shall be directed as shown in drawing. (Cutted
surface shall be directed backward).
E. Gear position switch lead and AC magneto lead
shall not slack.
F. AC magneto and neutral connector shall be
covered by connector cover.
G. Negative battery lead shall be clamped at lower
side of wire harness assembly.
H. Plastic band shall not be cut. Tip of plastic band
shall be directed outside. Plastic band shall be
through hole of frame components.
I. Negative battery lead, AC magneto and gear
position switch lead shall be clamped to cross tube
on protector at outside of engine stay mounting
bracket.
J. Clamp of wire harness shall be inserted to frame
component.
K. Each hose shall not be stacked with each other.
L. Pass fuel drain pipe through inside of engine stay.
M. Pass fuel drain hose and breather hose through
the slit of mud guard.
2-38
SPEC