Yamaha R15 2022 Service Manual page 89

1. Headlight assembly lead
2. Meter assembly lead
3. Auxiliary light assembly lead (Right)
4. Throttle cable (Pull)
5. Throttle cable (Return)
6. VVA (Variable valve actuation) lead
7. Ignition coil
8. Turn signal relay
9. Fuel injector lead
10. Radiator fan motor relay
11. ABS hydraulic unit lead
12. Fuel injector
13. Fuel hose
14. Starter motor lead
15. Air filter assembly
16. Speed sensor lead
17. Fuel drain hose
18. Fuel pump assembly
19. Breather hose
20. Joint connector
21. Rectifier regulator assembly
22. Radiator fan motor lead
23. Horn lead
24. Clutch cable
25. Left handlebar switch lead
26. Front left turn signal light lead
27. Auxiliary light assembly lead (Left)
28. Headlight stay
29. Front right turn signal light lead
30. Meter bracket
31. Meter assembly
32. Meter assembly cover
33. Headlight Light control unit
34. Headlight assembly
35. Wire harness
36. Frame component
37. Engine stay
38. Plastic band
39. Radiator cover
40. Front turn signal light lead (Left & Right)
41. Left & right side inner panel
CABLE ROUTING
A. Fuel pump assembly lead and fuel sender lead
shall pass above ABS hydraulic unit.
B. ABS hydraulic unit lead shall be touched with wire
main harness assembly.
C. The plastic band shall be tighten after joint
connector lead clamp insert into the frame
component.
D. This connector is prepare for accessory.
E. Clamp left auxiliary light lead on surface of
headlight stay.
F. Meter assembly lead and headlight assembly lead
shall be set as shown in this drawing.
G. Pass the headlight control unit lead into headlight
assembly guide.
H. Plastic band shall not be cut, tip of plastic band
shall be directed front, wire harness assembly shall
be clamped to frame component on white tape.
I. Wire harness assembly shall be clamped to frame
component at outside of engine stay. Tip direction
of plastic band shall be same as "J". Do not cut
plastic band .
J. Plastic band shall be set as shown in this drawing.
tip of plastic band shall not come out of hatching
area.
K. Plastic band of wire harness shall be inserted into
4th hole of frame component.
L. Do not cut plastic band, direct tip of plastic band
forward.
M. Pass the radiator fan motor lead through hole of
radiator cover.
N. Pass the front turn signal light lead (Left & Right)
in the structure of left & right side inner panel. After
connected with main wire harness assembly lead
of front turn signal light (left & right) shall pull in
direction of arrow.
O. Connector of auxiliary light assembly (left & right)
shall be inserted into headlight stay.
P. Clamp of wire harness shall be inserted into
headlight stay.
2-32
SPEC