Brother GTX600NB Instruction Manual page 279

Error code Error message
2300 [Special work mode]
[Power was off for long
time
2330
Executing recovery
operation]
[Long Power―OFF
2335
Detection]
2340 [Waste ink tank full]
2341 [Waste ink tank full]
[Waste ink tank not in
2342
position]
2345 [Right door open]
2346 [Left door open]
2347 [Upper door open]
2350 [Right mist fan door open]
2351 [Left mist fan door open]
[PC Communication
3000
Error]
[PC Communication
3001
Error]
3002 [PC Data Error]
3003 [PC Data Error]
Description
Under the operation by the
service engineer
The power has been turned
off for a long time and a
recovery operation is
required.
A state in which no recovery
operation has been executed
since the power was turned
off for a long time.
The waste ink tank is full.
The waste ink tank will be full
soon.
The waste ink tank is not
installed.
The right door is open.
The left door is open.
The upper door is open.
The mist fan door on the right
side is open.
The mist fan door on the left
side is open.
Data reception from the PC
has been suspended.
Data transmission to the PC
has been suspended.
Abnormal data has been
received from the PC.
Unsupported data has been
received from the PC.
9-8
Remedy
If the problem persists even after reactivating
the printer, please contact your dealer.
Follow the on-screen instructions and click the
OK button to execute the recovery sequence.
The recovery sequence depends on the length
of time the printer is left turned off.
Follow the on-screen instructions and click the
OK button to execute the recovery sequence.
The recovery sequence depends on the length
of time the printer is left turned off.
Empty the waste ink tank.
Empty the waste ink tank.
Install the waste ink tank.
Close the right door.
Close the left door.
Close the upper door.
Close the mist fan door on the right side.
Close the mist fan door on the left side.
Make sure that your PC is connected to the
printer, and resend the print data. If you have
trouble, restart your PC and the printer.
This error will also occur "when the cable is
removed during data reception" or "when the
ongoing operation is canceled on the PC during
data reception".
Make sure that your PC is connected to the
printer, and start operating the PC tool over from
the beginning. If you have trouble, restart your
PC and the printer.
This error may also occur "when the cable is
removed during data transmission" or "when the
PC tool is caused to stop running on the PC
during data transmission".
Make sure that your PC is connected to the
printer, and resend the print data. If you have
trouble, restart your PC and the printer.
Update both the printer driver installed on the
PC and the firmware of the printer to the latest
version.
Error message