Brother GTX600NB Instruction Manual page 254

Probable Cause
Do you find that the temperature
of print heads are becoming
high, and [Color Head Getting
Warm] or [W Head Temp Rising]
message appears?
Is the printer cover open?
Is the mist fan door open?
Is the mist fan filter set correctly? Set the mist fan filter correctly and close the mist
The power cannot be turned on
Probable Cause
Is the power cord connected to
the printer?
An error occurs immediately after activating the printer
Probable Cause
Is any error message
displayed?
No print data can be loaded from USB flash memory
Probable Cause
Is the applicable file ARP or
AR3 file?
Neither uni-directional printing nor bi-directional printing can be performed
Probable Cause
Do the settings of printer driver
and printer agree with each
other?
The depletion of ink in an ink tank cannot be detected
Probable Cause
Check if the remaining ink level
correction was skipped or an
incorrect value was entered for
the correction.
Remedy
There may be the possibility that the flat cables
of print heads have not been put in place and
the temperature of print heads has become high.
Turn off the power, make sure that the flat cable
is in place, and wait until the temperature
decreases.
Close the printer cover and try printing again.
Close the mist fan door and try printing again.
fan door. Then try printing.
Remedy
Make sure that the power cord is connected to
the printer.
Remedy
Check the content of the error, and restart the
printer. If the error is still not eliminated, please
contact your dealer or Brother.
Remedy
This printer cannot print out the print data of
GT-541/GT-782/GT-3. Recreate the print data.
Remedy
Note that the setting of the printer's setting has
priority over the setting of printer driver. The
printer driver's setup value takes effect only if the
printer's setting is [Auto].
Remedy
Perform the remaining ink level correction again.
8-3
Troubleshooting
Reference
-
-
"6-1-10. Replacing the mist fan
filter >>P.6-28"
"6-1-10. Replacing the mist fan
filter >>P.6-28"
Reference
-
Reference
"9. Error message >>P.9-1"
Reference
-
Reference
"7-1. Setting the print direction
>>P.7-3"
Reference
"6-1-4. Correcting the remaining
ink level >>P.6-10"