Brother GTX600NB Instruction Manual page 261

Probable Cause
Did you shake the pretreatment
after its dilution?
Is the [Low Temperature Mode]
set to [Disable]?
Has the pretreatment been
fixated insufficiently?
Whiteness of print result is insufficient
Probable Cause
Has the pretreatment been
applied insufficiently?
Has the pretreatment been
fixated insufficiently?
Is there any nozzle that does not
eject ink-jet droplets?
Is the white ink circulated
insufficiently?
Is the [Low Temperature Mode]
set to [Disable]?
Is the dilution rate of the
pretreatment correct?
Is the [Highlight:] of [White Ink
Settings:] too low?
Too much luster
Probable Cause
Are you using Teflon-treated
peel-off sheet for fixation?
Too fuzzy
Probable Cause
Did you touch the print media
(T-shirt) just before printing?
Remedy
Shake the pretreatment sufficiently.
Change the setting to [Enable (Normal)].
Check on an actual temperature of the heat
press and its pressure during the fixation stage.
Always keeping the lower iron (where media is
placed) of the heat press at heated temperature
with a heating source may solve this problem.
Remedy
Apply a proper amount of pretreatment.
Check on an actual temperature of the heat
press and its pressure during the fixation stage.
Perform [Head Cleaning] from the menu.
If no improvement is attained, follow the
referenced instructions.
From the menu, select [Maintenance] > [White
Ink Circulation] to circulate the white ink
properly.
Change the setting to [Enable (Normal)].
Dilute the pretreatment appropriately.
Print the highlight check pattern to check the
blurring, and select appropriate set value for
[Highlight:].
Remedy
Use a silicon coated peel off sheet when curing
the ink to reduce the gloss.
Remedy
Excessively touching the media (T-shirt) on the
platen by trying to flatten the media before
printing could cause fuzziness. Make sure not to
touch the media surface too much after the
pretreatment is fixated.
8-10
Troubleshooting
Reference
"5-3-2. Dilution of pretreatment
>>P.5-7"
"7-10. Print Operation Settings
Under Low Temperature
>>P.7-8"
"5-3-4. Fixation of pretreatment
>>P.5-12"
Reference
"5-3-3. Application of
pretreatment >>P.5-9"
"5-3-4. Fixation of pretreatment
>>P.5-12"
"8-2-1. Recovery action to be
taken for such a nozzle that is
unable to eject ink-jet droplets
>>P.8-13"
-
"7-10. Print Operation Settings
Under Low Temperature
>>P.7-8"
"5-3-2. Dilution of pretreatment
>>P.5-7"
"4-6-6. Print out of highlight
check pattern/mask check
pattern >>P.4-53"
"4-4-6. Set up the white ink
>>P.4-28"
Reference
-
Reference
-