Mercedes-Benz EQS 2021 Operator's Manual page 667

You require the following tools, for example, to
change a wheel:
Jack
R
Chock
R
Wheel wrench
R
Centring pin
R
%
The jack weighs approximately 3.4 kg.
The maximum load capacity of the jack can
be found on the sticker affixed to the jack.
The jack is maintenance-free. If there is a
malfunction, please contact a qualified spe-
cialist workshop.
The tyre-change tool kit is located in tool bag
in the boot.
%
Depending on the vehicle equipment, the tool
bag may be located at other positions in the
boot.
The tool bag contains:
Jack
R
Gloves
R
1
Wheel wrench
R
Centring pin
R
Folding chock
R
Ratchet for jack
R
Preparing the vehicle for a wheel change
Requirements:
The vehicle is not on a slope.
R
ohne
Wheels and tyres 665
The vehicle is on solid, non-slippery and level
R
ground.
The required tyre-change tool kit is available.
R
%
If your vehicle is not equipped with the tyre-
change tool kit, consult a qualified specialist
workshop to find out about suitable tools.
Apply the electric parking brake manually.
#
Move the front wheels to the straight-ahead
#
position.
Shift the transmission to position j.
#
Vehicles with AIRMATIC: set the raised vehicle
#
level for greater ground clearance
( page 366).
/
Switch off the vehicle.
#
Make sure that the vehicle cannot be started.
#
Place chocks or other suitable items under the
#
front and rear of the wheel that is diagonally
opposite the wheel you wish to change.
Unload the vehicle.
#