Mercedes-Benz EQS 2021 Operator's Manual page 53

When closing the fuse box, make sure
#
that the seal of the lid is positioned cor-
rectly on the fuse box.
If the newly inserted fuse also blows, have the
cause traced and rectified at a qualified specialist
workshop.
Ensure the following before replacing a fuse:
The vehicle is secured against rolling away.
R
All electrical consumers are switched off.
R
The vehicle is switched off.
R
The electrical fuses are located in various fuse
boxes:
Fuse box on the driver's side of the cockpit
R
( page 655)
/
Fuse box in the front passenger footwell
R
( page 655)
/
Fuse box in the rear passenger compartment
R
( page 655)
/
Notes on flat tyres
& WARNING Risk of accident due to a flat
tyre
A flat tyre severely affects the driving charac-
teristics as well as the steering and braking of
the vehicle.
Tyres without run-flat characteristics:
Do not drive with a flat tyre.
#
Change the flat tyre immediately with an
#
emergency spare wheel or spare wheel.
Alternatively, consult a qualified special-
ist workshop.
Tyres with run-flat characteristics:
Observe the information and warning
#
notes on MOExtended tyres (run-flat
tyres).
In the event of a flat tyre, the following options are
available depending on your vehicle's equipment:
Vehicles with MOExtended tyres: it is possible
R
to continue the journey for a short period of
time. Make sure you observe the notes on
ohne
Electronic information products
MOExtended tyres (run-flat tyres)
( page 640).
/
Vehicles with a TIREFIT kit: you can repair the
R
tyre so that it is possible to continue the jour-
ney for a short period of time. To do this, use
the TIREFIT kit ( page 641).
/
Vehicles with Mercedes me connect: you can
R
make a call for breakdown assistance via the
overhead control panel in the case of a break-
down ( page 563).
/
All vehicles: change the wheel (
R
Overview of the tyre-change tool kit
Apart from some country-specific variants, vehi-
cles are not equipped with a tyre-change tool kit.
For more information on which tyre-changing
tools are required and approved for performing a
wheel change on your vehicle, consult a qualified
specialist workshop.
You require the following tools, for example, to
change a wheel:
Jack
R
Chock
R
51
page 665).
/