Garmin G1000 NXi Pilot's Manual page 76

FLIGHT INSTRUMENTS
Bearing Station
to Source Identifier
Bearing 1 Information Window
When a bearing pointer is displayed, the associated information window is also displayed. The Bearing
Information windows are displayed below the HSI and give the following information:
» Bearing source (NAV, GPS, ADF)
» Pointer icon (BRG1 = single line, BRG2 = double line)
» Station/waypoint identifier (NAV, GPS)
When the NAV radio is tuned to an ILS frequency the bearing source and the bearing pointer is removed
from the HSI. When NAV1 or NAV2 is the selected bearing source, the frequency is replaced by the station
identifier when the station is within range. If GPS is the bearing source, the active waypoint identifier is
displayed instead of a frequency.
The bearing pointer is removed from the HSI and dashes are displayed in the information window if the
NAV radio is not receiving a VOR station or if GPS is the bearing source and an active waypoint is not selected.
Selecting bearing display and changing sources:
1) Press the PFD Opt Softkey.
2) Press either Bearing 1 or Bearing 2 Softkey to display the desired bearing pointer and information window
with the NAV1 source.
3) Press the bearing softkey again to display the bearing pointer with the NAV2 source.
4) Press the bearing softkey again to display the bearing pointer with GPS as the source.
5) Press the bearing softkey again to display the bearing pointer with the optional ADF as the source.
6) To remove the bearing pointer and information window, press either Bearing 1 or Bearing 2 Softkey again.
56
DME Information Window
Tuning Mode
Frequency
Distance
Figure 2-21 HSI with Bearing and DME Information
Garmin G1000 NXi Pilot's Guide for the Cessna NAV III
Bearing 1 Bearing 2
Pointer Pointer
Pointer
Icon
Bearing 2 Information Window
» GPS-derived great circle distance to bearing
source
» Frequency (NAV)
Bearing Distance to
Source Bearing Source
190-02177-02 Rev. A