Garmin G1000 NXi Pilot's Manual page 356

HAZARD AVOIDANCE
Switching between TIS modes:
1) Select the 'Map - Traffic Map' Page.
2) Press the Standby or Operate Softkey to switch between modes. The mode is displayed in the upper right
corner of the 'Map - Traffic Map' Page.
Or :
a) Press the MENU Key.
b) Select 'Operate Mode' or 'Standby Mode' (choice dependent on current state) and press the ENT Key.
The annunciations to indicate the status of traffic information appear in a banner at the lower left corner of
maps on which traffic can be displayed, as shown in the following table.
Traffic Status Banner
Annunciation
TA OFF SCALE
TA X.X ± XX ↕
AGE MM:SS
TRFC COAST
TRFC RMVD
TRFC FAIL
NO TRFC DATA
TRFC UNAVAIL
*Shown as symbol on 'Map - Traffic Map' Page
**Shown in center of 'Map - Traffic Map' Page
336
A Traffic Advisory is outside the selected display range*
Annunciation is removed when traffic comes within the selected display range
System cannot determine bearing of Traffic Advisory**
Annunciation indicates distance in nm, altitude separation in hundreds of feet, and
altitude trend arrow (climbing/descending)
Appears if traffic data is not refreshed within 6 seconds
If after another 6 seconds data is not received, traffic is removed from the display
The quality of displayed traffic information is reduced as the age increases
The displayed data is not current (6 to 12 seconds since last message)
The quality of displayed traffic information is reduced when this message is displayed
Traffic is removed because it is too old for coasting (12 to 60 seconds since last message)
Traffic may exist within the selected display range, but it is not displayed
Traffic data has failed
Traffic has not been detected
The traffic service is unavailable or out of range
Table 6-21 TIS Traffic Status Annunciations
Garmin G1000 NXi Pilot's Guide for the Cessna NAV III
Description
190-02177-02 Rev. A