Tis Alerts - Garmin G1000 NXi Pilot's Manual

Range
Marking
Rings
Traffic Advisory, 500'
Below, Climbing
Off-Scale Traffic
Advisory
400' Below, Level
Traffic Status Banner
Annunciations

TIS ALERTS

When the number of TAs on the 'Map - Traffic Map' Page increases from one scan to the next, the following
occur:
- A single "Traffic" voice alert is generated.
- A 'TRAFFIC' Annunciation appears to the right of the airspeed tape, flashes for five seconds, and remains
displayed until no TAs are detected in the area.
- The PFD Inset Map or HSI Map is automatically displayed with traffic.
To reduce the number of nuisance alerts due to proximate aircraft, the "Traffic" voice alert is generated only
when the number of TAs increases. For example, when the first TA is displayed, a voice and visual annunciation
are generated. As long as a single TA remains on the display, no additional voice alerts are generated. If a second
TA appears on the display or if the number of TAs initially decreases and then subsequently increases, another
voice alert is generated.
190-02177-02 Rev. A
Figure 6-75 'Map - Traffic Map' Page
Garmin G1000 NXi Pilot's Guide for the Cessna NAV III
HAZARD AVOIDANCE
Traffic Mode Annunciation
"TIS Not Available"
Voice Alert Status
Non-Threat
Traffic, 2500'
Above,
Descending
"Non-Bearing" Traffic
(System Unable to
Determine Bearing)
Distance is 4.0 nm,
500' Above,
Descending
Press to Mute
"TIS Not
Available"
Voice Alert
333