Table of Contents
Advertisement
Mounting
After the modules have been plugged together secure them in place using
Lock the modules
the two connecting clips provided so that the modules cannot be twisted
together using the
or moved apart. Proceed as follows:
connecting clips
1. Insert a connecting clip from top between the two modules to be
2. Align the connecting clip, so that the angled section of the clip is
Fig. 3-6
3. Then press downwards on the connecting clip at the two ends which
4. Repeat steps 1 to 3 at the lower side of the modules to be latched
3-6
clipped together until the bent clip ends come into contact with the
housing cover of the modules.
located above a grid hole of the module housing cover. The first bent
clip end should be located above the 5
module.
Locking the modules together using a connecting clip (schematic diagram)
are bent at right angles until they latch into place.
together.
th
grid hole from the rear of the
Application Module FM 458 - User Manual
6DD1904-0AE0
Edition 12.2001
Advertisement
Table of Contents
