Siemens SIMADYN D FM 458 User Manual page 116

The following also applies:
*.csv format
• A tabular file may only comprise two columns - if there are additional
• Both columns must include the same number of values. If this is not
The D7-SYS additionalComponentBuilder expects REAL values (for type
description "Table REAL") in the subsequent data format:
• [+/-] xxx.yyy – real value, decimal places are specified by "." (e.g.
• [+/-] xxx,yyy – real value, decimal places are specified by "," (e.g.
• [+/-] xxx.yyyE+mm – real value as an exponential, decimal places are
• [+/-] xxx,yyyE+mm – real value as an exponential, decimal places are
It is illegal to represent REAL values as follows:
• [+/-]xx.xxx,yyy – real value, thousands positions are represented using
Double integer values (for the "table DINT" type description) expect the
ComponentBuilder in the following data format:
• [+/-]xxx – integer or double integer (e.g. 145)
The two following diagrams show two typical files with tabular values:
Fig. 4-36
Application Module FM 458 - User Manual
6DD1904-0AE0 Edition 12.2001
columns in the table, then an error message is output in a dialog box.
the case, then the D7-SYS additionalComponentBuilder outputs an
error message in a dialog box and the tabular values are rejected.
145.123)
145,122)
specified by "." (e.g. 145.122E+12)
specified by "," (e.g. 187,122E+12)
"." and decimal places by ",".
Example of a file with tabular values, separated by semicolon (*.csv format)
Configuring
4-61