Table of Contents
Advertisement
After the file has been opened, it can be edited in the "LAD/STL/CSF"
program. There it can be compiled via "File / Compile".
The procedure is shown in the following diagram:
Fig. 4-33
Compiling the source file in the "LAD/STL/CSF" application
After the file has been successfully compiled, a new DB is available in the
configured software. The name of the DB corresponds to the name
specified in the header line of the file.
The following diagram illustrates the newly generated DB in STEP7
configured software under "Blocks":
Application Module FM 458 - User Manual
6DD1904-0AE0
Edition 12.2001
Configuring
4-55
Advertisement
Table of Contents
