Installation; Install The Toilet - Kohler K-4026 Series Installation And Care Manual

Installation

1. To Remove Existing Toilet
Turn off the water supply. Flush the toilet, and use a sponge to remove the remaining water from the tank
¨
and bowl.
Disconnect the supply shut-off valve (if present), and remove the old tank and bowl.
¨
Remove old gasket from the floor and floor flange with a putty knife. Remove old T-bolts and discard them.
¨
NOTICE: If a new toilet is not installed immediately, temporarily stuff a rag in the floor flange.
Floor Flange
T-Bolts
2. Roughing-In
DANGER: Risk of electric shock. Disconnect power before servicing.
NOTE: This product is designed to work with wall mounted electrical and water supplies. It is shown in the
roughing-in.
WARNING: Risk of electric shock. Connect only to circuits protected by Ground-Fault
Circuit-Interrupters (GFCI) or Earth-Leakage Circuit-Breakers (ELCB).
WARNING: Keep bath and shower away from electrical parts (such as remote control, receptacle, audio
input apparatus and so on).
When the electrical supply is mounted on the wall, a GFCI or ELCB protected and water proof receptacle
¨
is required.
Follow the dimensional information exactly when installing a hardwire electrical supply.
¨
Kohler Co.
Supply Stop
Floor Flange
The wall location of the electrical and
water supply are interchangeable.
GFCI-Protected 15A Receptacle (water proof)
150
305
9 1168908-X2-B