Table of Contents
Advertisement
INSTALLATION
TO INSTALL NEW SUPPLY SHUT-OFF
VALVE
Remove old gasket from the floor and closet flange with
a putty knife. Remove old T-bolts and discard.
NOTICE: If a new toilet is not installed immediately,
temporarily stuff a rag in the closet flange.
Install toilet supply shut-off valve so it is 9" above floorline
and 4-1/8" to the left of the centerline of the closet flange.
Centerline of supply shut-off outlet should extend 4" from
finished wall. Install the supply shut-off valve with outlet
vertical.
Install new 5/16" diameter T-bolts.
TO INSTALL NEW TOILET
Place new toilet upside down on padding. Firmly place
gasket on toilet outlet.
NOTE: If using gasket with integral plastic sleeve, make
sure the gasket is positioned facing away from the toilet.
Remove rag from closet flange before setting toilet.
Carefully align and lower toilet over the closet flange and
bolts.
CAUTION: Do not lift or rock toilet after placement;
a new gasket must be reapplied if you break the
watertight seal.
Apply full body weight to toilet rim to set seal.
Kohler Co., Kohler, WI
9"
12"
T-Bolts
Toilet Outlet
3
Closet Flange
Fig. #2
Supply Shut-Off
Valve
4-1/8"
Fig. #3
Closet Flange
Fig. #4
Gasket
Fig. #5
BA
111469-2-
(-)
Advertisement
Table of Contents
