Replacing The Media Edge Plates; Replacement Procedure - Epson SC-S80600 Series User Manual

SC-S80600 Series/SC-S80600L Series/SC-S60600 Series/SC-S60600L Series/SC-S40600 Series User's Guide
I
Insert the two hooks on the flushing pad into the
slots on the printer and press the tab down until
the pad clicks into place.
J
After replacing the flushing pad, press the Z
button.
K
Remove both of the new air filters from the
packaging.
L
Grip the air filters and lift them straight out.
Replace both of the air filters.
M
Place the removed air filters in the packaging that
contained the new air filters.
N
Insert the new air filters.
Maintenance
O
Check that the air filters are installed, and then
press the Z button.
c
Important:
Make sure you install the air filters.
If the printer is used when the air filters are not
installed, sensors may degrade due to mist
causing misalignment in print and the printer
may malfunction.
P
Close the maintenance cover, and then press the
Z button.
Q
A confirmation message is displayed on the
screen. Check the content of the message, select
Yes, and then press the Z button.
Disposing of used maintenance parts U
page 84
Replacing the media edge
plates
When the media edge plates supplied with the printer
are deformed or damaged, be sure to replace them with
new ones.
media edge plates available on the printer
"Options and Consumable Products" on
U
page 123
c
Important:
If a deformed or damaged media edge plate
continues to be used, it may result in damage to the
print head.

Replacement procedure

A
Remove media, and turn off the printer. Check
that the screen display has turned off, and then
unplug the power cable from the outlet.
"Removing the Take-up Roll" on page 51
U
Disconnect both of the power cables.
81
"Disposal" on