Epson SC-S80600 Series User Manual page 50

SC-S80600 Series/SC-S80600L Series/SC-S60600 Series/SC-S60600L Series/SC-S40600 Series User's Guide
The approximate maximum length of the media
required to print the test pattern is given below.
When performing Standard: Approximately 130 mm
When performing 500mm Pattern: Approximately 770
mm
Setting procedure
A
Check that the printer is ready, and load the
media according to the actual usage conditions.
When using the Auto Take-up Reel Unit, attach
the media to the roll core.
"Loading media" on page 30
U
"Using the Auto Take-up Reel Unit" on
U
page 36
B
Press the Menu button.
The settings menu will be displayed.
C
Select Media Setup - Customize Settings -
Media Adjust - Manual - Feed Adjustment.
D
Use the d/u buttons to select Standard or 500
mm.
E
Press the Z button to print the adjustment
pattern.
Wait until printing is complete.
F
Check the printed adjustment pattern.
When Standard is selected
Two groups of adjustment patterns, A and B, are
printed. Select the pattern with the least amount
of overlapping or gaps for each group. Select "0.0"
in the cases shown below.
Basic Operations
If there are patterns where the overlapping or
gaps are the same, enter the middle value in step
7. Enter "-0.05%" in the cases shown below.
If all of the adjustment patterns contain
overlapping or gaps, select the pattern with the
least overlaps or gaps.
In this situation, follow the steps below to
complete media feed adjustment, and then
perform 500mm Pattern for media feed
adjustment.
When 500mm Pattern is selected
Measure using a scale of up to 0.5 mm.
G
The screen for entering confirmation results for
the adjustment pattern is displayed.
When Standard is selected
Set the values printed under the patterns selected
in A and B, and then press the Z button.
When 500mm Pattern is selected
Set the value established in step 6, and then press
the Z button.
When settings are complete, the status display
screen is displayed.
Head Alignment
Depending on the model or setting status being used,
the maximum length of the media required to print the
test pattern differs as shown below.
50