Understanding The Display - Epson SC-S80600 Series User Manual

SC-S80600 Series/SC-S80600L Series/SC-S60600 Series/SC-S60600L Series/SC-S40600 Series User's Guide
❏
When the media loading lever is lowered
Press the d button to feed the media and the u button
to rewind it.
Press and hold the button to speed up the media feed.
If you are using the SC-S80600L Series/SC-S60600L
Series, give the button 1 short press to allow the media
to be fed in 0.4 mm increments. This helps when
fine-tuning the alignment of the media.
Note that when the u button is used to rewind, the
media will stop when its edge reaches the starting
print position. Rewind can be resumed by releasing
the button and then pressing it again.
❏
When the media loading lever in a raised position, the
button to rewind media depends on how the loaded
media is rolled.
Printable Side Out: Press the u button.
Printable Side In: Press the d button.
Keep the button pressed to rewind the media up to
25 cm.
❏
When the menus are displayed, these buttons can be
used to select menu items and options. U
Operations" on page 96
I
Z button
❏
Pressing this button when a menu item is highlighted
displays options for the selected item.
❏
Pressing this button when an option is highlighted
selects the highlighted item or performs the selected
operation.
❏
Pressing this button while the alert buzzer is sounding
stops the buzzer.
J
[ ] button (heating/drying button)
Pressing this button displays the Heating & Drying
menu on the screen to perform Start Preheat,
Heater Temperature, Drying Time Per Pass, and
After Heater Feed. If the Additional Print Drying
System (supplied with the SC-S60600 Series/
SC-S60600L Series; optional with other models) is
attached, you can also adjust Additional Dryer
settings. These options can be adjusted during
printing.
"Changing the Heater Temperature and Drying
U
Settings" on page 55
K
# button (maintenance button)
Introduction
Pressing this button displays the Maintenance menu
on the screen to perform Nozzle Check, Cleaning,
Head Maintenance, Replace Ink Bottle, Head
Washing, and Pre-Storage Maint.. This button is
disabled during printing.
"The Maintenance Menu" on page 110
U
L
W button (pause/cancel button)
❏
The printer enters pause status if this is pressed while
printing. To release the pause status, press the W
button again, or select Pause Cancel on the screen
and then press the Z button. To cancel print jobs
being processed, select Job Cancel on the screen and
then press the Z button.
❏
Pressing this button when menus are displayed closes
the menus and returns the printer to ready status.
"Menu
M
[ ] button (light button)
Press when the internal light is on to turn off the
light.
Press when the internal light is off to turn on the
light.
However, when you press the button during an
operation that does not allow the light to turn on, the
light remains off.

Understanding the Display

The illustration shows the display for the SC-S60600
Series.
Ready
A
Messages
Displays the printer's status, operation, and error
messages.
"When a Message is Displayed" on page 115
U
16