When A Maintenance Call/Service Call Occurs - Epson SC-S80600 Series User Manual

SC-S80600 Series/SC-S80600L Series/SC-S60600 Series/SC-S60600L Series/SC-S40600 Series User's Guide
Messages
Roll Type Error
Release and then reset the media loading
lever, then match Roll Type setting to
actual media.
Press # and perform Head Maintenance.
3 layer printing is only available with 2
Head Mode.

When a Maintenance Call/Service Call Occurs

Error messages
Maintenance Request
Replace Part Now/Replace Part Soon
XXXXXXXX
Call For Service
XXXX Error XXXX
Power off and then on. If this doesn't work,
note the code and call for service.
Problem Solver
What to do
❏
Does the Roll Type specified at media loading match the actual roll type?
Raise the media loading lever to resolve the error. Lower the media loading
lever again, and follow the on-screen instructions of the printer to correctly
specify the Roll Type.
This message is displayed when regular cleaning has not been performed for
more than one month. If you continue to use the printer without performing
regular cleaning, ink drops, nozzle clogging, or print head damage may occur in
the printer.
"Performing Regular Cleaning" on page 65
U
SC-S80600 Series/SC-S80600L Series/SC-S60600 Series/SC-S60600L Series only
When one head mode is set, three layered printing cannot be performed. Set two
head mode, and then perform three layered printing.
Change head mode U "The Printer Setup Menu" on page 107
What to do
A part used in the printer is nearing the end of its service life.
Contact your dealer or Epson Support and tell them the maintenance request
code.
You cannot clear the maintenance request until the part is replaced. A service call
occurs if you continue to use the printer.
A call for service occurs when:
❏
The power cable is not connected securely
❏
An error that cannot be cleared occurs
When a call for service has occurred, the printer automatically stops printing. Turn
off the printer, disconnect the power cable from the outlet and from the AC inlet
on the printer, and then reconnect. Turn on the printer again multiple times.
If the same call for service is displayed on the LCD panel, contact your dealer or
EpsonSupport for assistance. Tell them the call for service code is "XXXX".
117