Siemens LMV5 Quick Start Manual page 204

Legend to address table
Access
Data format
[ ]
Data types
LMV5 QSG Rev 4
R
R / W
U16
S32
¹) Refer to section «Data structures»
* These parameters need not be continually written since they are stored in EEPROM,
which only permits a limited number of write accesses over its lifecycle (< 100,000)
TYPE Phys.
PT_PROZENT01 0...100 %
PT_PROZENTFU 0...110 %
PT_WINKEL -3.0...93.0°
PT_TEMP_ 0...2000°
DRUCK 32...3632 °F
0...100 bar
0...1449 psi
PT_LEISTUNG Modulating opera-
tion: 0...100 %
Multistage opera-
tion:
1001 = stage 1
1002 = stage 2
1003 = stage 3
PT_ADAPTION
0: Undefined
1: Identification completed, parameter determined
2: Undefined
3: Adaption aborted by user
4: Temperature differential too small, temperature will be lowered with low-fire
5: Monitoring time running
6: Delivery of identification load set
7: Error during identification (path)
8: Error during identification (internally)
9: Monitoring time running
10: Changeover from modulating to multistage during an identification
11: Timeout monitoring time
12: Timeout heating output on path with monitoring
Sec 8 Pg 10
Value can only be read
Value can be read and written
16 bit integer, not subject to sign
32 bit integer, subject to sign
Note:
In the AZL..., this data type is also used to
mark an invalid or non-available value by
using the value of «-1»
Data array
Int. range Resolution
0...1000 0.1 %
0...1100 0.1 %
-30...930 0.1°
0...2000 1 °C
32...3632 1 °F
0...1000 0.1 bar
0...1449 1 psi
0...1003 Modulating
operation:
0.1 %
Multistage
operation:
1
Conversion int. / phys.
/ 10
/ 10
/ 10
1
1
/ 10
1
Modulating operation:
/ 10
Multistage operation:
- 1000
www.scccombustion.com